Power; Power Cord - Extreme Networks BlackDiamond 6800 Hardware Installation Manual

S I
AFETY NFORMATION
P
OWER
This unit has two power inputs.
• Disconnect power before removing the back panel of the unit.
• The unit must be grounded.
• The unit must be connected to a grounded outlet to comply with European safety
standards.
• Do not connect the power supply unit to an A/C outlet without a ground
connection.
• The socket outlet must be near to the unit and easily accessible. You can only remove
power from the unit by disconnecting the power cord from the outlet.
• This unit operates under Safety Extra Low Voltage (SELV) conditions according to
IEC 950. The conditions are only maintained if the equipment to which it is
connected also operates under SELV conditions.
• The appliance coupler (the connector to the unit and not the wall plug) must have a
configuration for mating with an EN60320/IEC320 appliance inlet.
• France and Peru only
This unit cannot be powered from IT† supplies. If your supplies are of IT type, this
unit must be powered by 230V (2P+T) via an isolation transformer ratio 1:1, with the
secondary connection point labeled Neutral, connected directly to ground.
P C
OWER ORD
• This must be approved for the country where it is used:
USA and • The cord set must be UL-approved and CSA-
Canada
• The minimum specification for the flexible cord is
• The cord set must have a rated current capacity of
• The attachment plug must be an Earth-grounding
A-2
certified.
No. 16 AWG (1.5 mm
at least 10A.
type with a NEMA L6-20P (20A, 250V)
configuration.
2 ), Type SV or SJ, 3-conductor.
B D H I
LACK IAMOND ARDWARE NSTALLATION
G
UIDE