Extreme Networks BlackDiamond 6800 Hardware Installation Manual page 35

6 To install a second power supply, remove the blank plate from the power supply bay
on the right of the chassis using a #1 Phillips-head screwdriver.
7 Install the second power supply, as shown in
described in Step 5.
DC OUT
AC IN
Figure 2-3: Power supply bays
8 Prior to installing module cards into the BlackDiamond chassis, put on the ESD
wrist strap that is provided with the chassis, and connect the metal end to the
ground receptacle located on the top-left corner of the BlackDiamond front panel.
9 To install the MSM follow these steps:
a Ensure that the MSM is right side up (printed circuit board, or PCB, to the right),
the DIMM ejector locks are in the upright and locked position, and the
ejector/injector handles are extended, as shown in
B D H I
LACK IAMOND ARDWARE NSTALLATION
G
UIDE
Figure 2-3, by repeating the procedure
DC OUT
AC IN
Figure
I B D
NSTALLING THE LACK IAMOND
BD_pwrx
2-4.
2-5