Summary of Contents for Panduit Atlona Omega AT-OME-RX21-KIT
Page 1
Installation Guide AT-OME-RX21 Omega 4K/UHD Scaler for HDBaseT and HDMI AT-OME-RX21 The Atlona AT-OME-RX21 is an HDBaseT receiver and 4K/UHD scaler with a local HDMI input. Part of the Omega™ Series of integration products for modern AV communications and collaboration, the OME-RX21 receives HDBaseT for video up to 4K/60 4:2:0, plus embedded audio, control, and Ethernet over distances up to 330 feet (100 meters).
Page 2
Installation Guide AT-OME-RX21 Panel Descriptions AT-OME-RX21 LINK OMEGA OMEGA DEVICE IP INPUT PATTERN HDMI IN AT-OME-RX21 IP MODE C1 COM C2 HDBaseT IN OUTPUT RESET RS-232 RELAY DC 24V PWR LED HDBaseT IN Illuminates green when receiving power. Connect a compatible HDBaseT transmitter to this port.
Page 3
Installation Guide AT-OME-RX21 RS-232 A 5-pin captive screw connector has been included for RS-232. NOTE: Port 1 is for display control and port 2 will control the unit. Pin out will be determined by the RS-232 cable and connect as RX (receive), TX (transmit) and (Ground).
Installation Guide AT-OME-RX21 Mounting Instructions The AT-OME-RX21 includes two mounting brackets and four mounting screws, which can be used to attach the units to any flat surface. Remove the top 2 case screws on the side of the unit. Align the mounting brackets to the side of the units. Use the previously removed case screws to secure the mounting bracket to the enclosure.
Installation Guide AT-OME-RX21 Cable Recommendation Guidelines Refer to the tables below for recommended cabling when using Altona products with HDBaseT. The green bars indicate the signal quality when using each type of cable. Higher-quality signals are represented by more bars. Core Shielding CAT5e...
Installation Guide AT-OME-RX21 DHCP By default, the AT-OME-RX21 is set to DHCP mode. In this mode, when the AT-OME-RX21 is connected to the Local Area Network (LAN), it will automatically be assigned an IP address by the DHCP server (if available). Press the DEVICE IP button to show the IP address in the top left corner of the display.
Page 7
Installation Guide AT-OME-RX21 AMS 2.0 For easy configuration of Atlona devices , AMS 2.0 is available from https://atlona.com/ams for free. Two options can be used for installation: The free Linux based software download or the easy to install server hardware (AT-AMS-HW). Once AMS has been set up: Open a browser on the same network as AMS 2.0 and go to the IP address of AMS 2.0.