Cleanness And Maintenance; Troubleshooting Guide - Galanz XQB80-G1E Owner's Manual

Cleanness and Maintenance

Before maintenance, please disconnect the power plug.
Maintenance Method
Cleaning for Line Debris Filter
When in cleaning, you must use a line debris filer.
After each use, you must clean it in time. Please clean it according to the
following steps:
1.Take off the line debris filter. As shown in the figure, press the claw of
the filter by hands, and then draw it upward.
2.Overtum the wastepaper box, and then clean the wastepaper box and
the filter.
3.Hold the handle of the filter, you can install it by pressing handle; make
sure the filter claw be embedded into a corresponding part.
Cleaning the Water Filter
After being used for long time, the water inlet filter may be blocked by
fouling, clean it according to the following steps:
1.Close the tap and connect to the power.
2.Start the washing machine for 5 seconds (make the water in the inlet
hose flow into the washing drum),and then cut off the power.
3.Remove the inlet hose, clean the removable feed valve and feed screen,
and then install them well again.

Troubleshooting guide

Symptom
1.Is the inlet hose well connected?
2.Is the tap turned on?
E1
3.Is the water inlet filter blocked?
4.Is the inlet hose frozen?
E2
Is the cover closed well?
1.Is the drain hose installed properly?
2.Is the drain hose blocked by heavy object?
E3 3.Is the drain hose bent?
4.Is the drain hose blocked by extraneous matter?
5.Is there water frozen inside the hose?
This is not a failure. Since distribution of clothes
inside the drum is not even, the washing machine
E4
can not run normally in dehydration?
1.Whether is the wire connected?
2.Whether is the switch sensor beyond the normal
E5
range value?
3.Whether the air pipe leak?
1.Is there any problem with inlet valve?
E6
2.Whether is water frequency value beyond over
fall value?
1.Is the washing machine connected to power?
The washing
2.Is the power fuse disconnected?
machine can't
3.Is the cover closed well?
be started.
4.Is the "Start/Pause" pressed?
1.Is the washing machine placed on uneven ground?
Intensive
2.Are clothes inside the inner drum of the washing
vibration
machine in even distribution ?
or noise.
1.Is to much cleaning agent added?
Too much
2.Is cleaning agent with few bubbles that is special
bubboe
for full auto washing machines applied?
Water inlet
It is caused bu abnormality of the inlet valve or the
cannot Stop
level sensor.
If there are other problems that cannot be solved, please contact local After-
details.
Possible Cause
Connect the inlet hose properly (see P4. P5).
Turn on the tap.
Clean the water inlet filter (see P8).
Solve the frozen problem .
Close the cover well.
Lay down the drain hose.
Take the heavy object away.
Straighten out the drain hose.
Clean out the extraneous matter inside the hose.
Defreeze the hose with water of 50°C
Put the clothing into the drum well, and restart the washing
procedure.
Based on the schematic wiring diagram to connect the wire.
Change new switch sensor.
Change new air pipe.
Change new inlet valve.
Restart to wash chosen program.
Connect to the power and plug the socket .
Replace the broken fuse by a new one.
Open the cover and close it .
Press "Start/Pause".
Locate the washing machine on even ground and adjust
the adjustable feet to make the machine level.
Distribute laundries inside the inner drum again to reach
good balance.
Add adequate cleaning agent.
Use cleaning agent properly.
Turn off the tap and disconnect the power plug,
and then contact Afteer-Sales Service Department.
8
Press down
Take out
Solutions
Sales Service Center with failure