Galanz XQB80-G1E Owner's Manual page 18

4. Connection between inlet Hose and Washing Machine.
Please do not take down the absorbent pad, and check if
the absorbent pad drops off or damages before using the
washing machine each time; if such situation
happens, please contact our After-sales Service
Department in time.
Set the inlet hose nut into the inlet valve joint.
Screw down the inlet hose nut and check if it is
fastened properly by shaking it slightly.
Modification Method for Drain Hose
The drain hose is installed at the left side of the washing machine originally, but you can change it to
the right side according to the water discharge site.
Lay down the washing machine from back side lightly
.(Figure 1)
Take out the hose from left-side groove then put into
the right-side groove.
See the position of the drain hose (Figure 2)
Push back the rat guard from left to right at the bottom,
raise the machine lightly,and finally hit four screws.
The Use of Drain Hose
The distance between the drain hose and the ground
should be less than 10cm, otherwise it will cause
poor drainage, and too much time in drainage, as
well as the washing machine will stop.
If the drain hose is too long, you can cut off it in
central part; you can cut crosswise the front part
of the drain hose.
Automatic Detection
1.Washing Input
Put the washing into the washing machine, and press the "Power" switch, and then press the key of
"Start/Pause".
2.Aytinatucally Rotating for about 7 Seconds
The impeller will automatically rotate for about 7 seconds to sense the volume of cloth in the state of
no water.
3.Water Level Display
The washing machine will display the water level according to the volume of cloth, and water will
automatically input into it for reaching the indicated water level.
Inlet hose Nut
Inlet hose Joint
Absorbent Pad
Figure 1
Trampling and pressing the drain hose are
strictly prohibited.
If the drain hose needs to be lengthened,
please buy another long drain hose, and the
diameter of the extended drain hose should
be more than 30mm, while the total length
should be less than 3m.
5
Retrofit of drains
Figure 2