Galanz XQB80-G1E Owner's Manual page 17

Level Adjustment
The machine must stand perfectly level on all four feet to ensure safe and proper operation. Incorrect
installation may increase electricity and water consumption and may case the machine to move about.
To do these when the machine is not level:
Put up the leveler side slightly.
Rotate the leveler and regulate it at a required height.
Inlet Hose Connection
When using the washing machine, connect one end of the inlet hose with the washing machine and the other
with a tap.
1. Appropriate Tap
Common Tap
The outlet length of the tap must be over 10 mm. The tap must be
even, if it's uneven, please file it down by a file.
Specialized Tap
The exterior angle of outlet end should be in a round angle and the surface
should be smooth, otherwise the rubber sealing ring of the hose would be
damaged to cause water leakage.
When install the inlet hose, please pay attention to connect it or put it down
vertically, and it should be fastened up without loosening phenomenon after being connected.
If an appropriate specialized tap is used, an lnlet hose joint needs not to be installed.
2. Connection between inlet Hose Joint and Tap
Press the lower end of the locking bar to push slider down, and get down the inlet hose joint from the
inlet pipe components, as shown in Figure 1. Loosen the four screws in the inlet hose joint properly, and
then set the inlet hose into the tap, as shown in Figure 2. (If the caliber of the tap is oversize slightly and
the inlet hose can not be connected, you can loosen the four screws and take down the lining. The
front end of the tap must be even, otherwise it will cause water leakage, as shown in Figure 3.)
Screw down the four screws at the inlet hose joint equally as shown in Figure 4.
Take the notice plate off and screw the tight nut according to the requirements of the figure, as shown
in Figure 5.
3. Connection between inlet Hose Joint and Tap
Press the slider and insert the inlet hose into the inlet hose joint.
Hang the inlet hose joint by the locking bar, and then put down
the slider till a sound of pop generates, as shown in Figure 1.
If the water tap is a screw type, assemble a water supply hose
that fits to the tap, as shown in Figure 2.
The inlet hose can not be bent by force.
When the installation is completed, please check that it will be
leakage or not.
Before using the washing machine each time, please check the
connection between the inlet hose joint and the tap, as well as check if the joint of inlet hose is firm so
as to prevent it from dropping off because of uncompleted installation.
Notice
plate
Locking
Bar
4
High
Leveler
Appropriate Common Tap
Inappropriate Tap
Appropriate Specialized Tap
Inlet hose
Joint
Slider
Low