Cleaning And Maintenance - Galanz WMUK004W User Instruction Manual

Cleaning and Maintenance

Disconnect the machine from the mains electricity supply and withdraw the plug from
the socket before cleaning the machine.
The washing machine must not be hosed down.
Cleaning the exterior
Clean the exterior with a mild non-abrasive cleaning agent or soap and water using a damp cloth.
Wipe dry with a soft cloth.
Do not use solvents, abrasive cleaners, glass cleaners or all-purpose cleaning agents.
These might damage plastic surfaces and other components because of the chemicals
they contain.
The washing drum
Clean the drum every 3 months by using the "Drum clean" programme.
Cleaning the drawer
Remove detergent residues regularly. Clean the drawer as follows:
Pull out the drawer until a resistance is felt. Press down the release catch and pull the drawer
out of the machine.
Remove the siphon from compartment and clean it.
Clean the dispenser using a brush and warm water.
Cleaning and Maintenance
Use process
Cleaning the drawer housing
Use a bottle brush to remove detergent residues
inside the drawer housing.
Cleaning the water inlet filter
Use pointed nose pliers to withdraw the plastic filter.
Clean, put back and secure. These filters should be
checked every 6 months or so, or more often if there
are frequent interruptions to the water supply.
Cleaning the drain pump filter
1. Disconnect the machine from
the mains electricity supply and
open the lower cover with a
screwdriver.
Important:
If the machine is exposed to temperatures below 0°C, certain precautions should be taken.
1. Turn off the water tap.
2. Unscrew the inlet hose.
3. Unhook the drain hose from the rear support and place the end of this hose and the
inlet hose in a bowl. Run the spin programme.
4. Disconnect the appliance.
5. Screw the inlet hose and reposition the drain hose.
6. When you intend to start the machine up again, make sure that the room temperature is
above 0°C.
The filter must be put back in place after cleaning.
2. Place a container under the pump.
Unscrew and remove the filter.
The filter should be cleaned every 2 months or when the
fault "E03" is displayed on the screen.
After use
3. Clean the filter carefully.