Bridge Filters; Figure 25: Bridge Filters - Allied Telesis AT-AR256E User Manual

34

Bridge Filters

The Bridge Filters allows you to enable, add, edit or delete the filter rules. When bridge filtering is enabled,
each frame is examined against every defined filter rule in sequence. When a match is found, the appropriate
filtering action (allow or deny) is performed. Up to 20 filter rules are supported with bridge filtering.
To configure Bridge Filters:
1. Select Advanced.
2. Select Application > Bridge Filters. This opens the Bridge Filters page.
3. Select Enable Bridge Filters.
4. To add a rule, enter the source MAC address, Destination MAC address and Protocol with
desired filtering type, then click Add.
You can also edit a rule that you created using the Edit checkbox. You can delete using Delete.
5. Click Apply to temporarily activate the settings.
6. To make changes permanent, click Save Settings.
All manuals and user guides at all-guides.com
AT-AR256E v3 - 4 Ports ADSL2/2+ Router - User Manual

Figure 25: Bridge Filters