Routing; Static Routing; Figure 39: Static Routing - Allied Telesis AT-AR256E User Manual

4 ports adsl2/2+ router

Hide thumbs Also See for AT-AR256E:

Table of Contents

All manuals and user guides at all-guides.com

AT-AR256E v3 4 Ports ADSL2/2+ Router User Manual

The following fields can be configured for Policy Routing:

• Destination IP address/mask

• Source IP address/mask

• Source MAC address

• Protocol (TCP, UDP, ICMP, etc)

• Source port

• Destination port

• Incoming interface

• DSCP

Routing

If the router is connected to more than one network, you may need to set up a static route between them.

A static route is a pre-defined pathway that network information must travel to reach a specific host or

network. You can use static routing to allow different IP domain users to access the Internet through the

router.

The New Destination IP is the address of the remote LAN or host to which you want to assign a static route.

Enter the IP address of the host for which you wish to create a static route here. For a standard Class C IP

domain, the network address is the first three fields of the New Destination IP, while the last field should be

0. The Subnet Mask identifies which portion of a IP address is the network portion and which portion is the

host portion. For a full Class C Subnet, the Subnet Mask is 255.255.255.0. The Gateway IP address should be

the IP address of the gateway device that allows for contact between the Gateway and the remote network

or host.

Table of Contents