Capacitor Module Connections - Allen-Bradley Kinetix 5500 User Manual

Chapter 5 Connect the Kinetix 5500 Drive System
Capacitor Module
Connections
98
Follow these guidelines when wiring the 2198-CAPMOD-1300 capacitor
module:
• Wire relay output (MS) connections to the Logix5000 controller
(optional).
• Refer to
Kinetix 5500 Capacitor Module
• Refer to
Kinetix 5500 Capacitor Module Status Indicators
troubleshooting the module status indicator and relay output.
• Refer to the installation instructions provided with your Bulletin 2198
capacitor module, publication 2198-IN004.
To improve system performance, run wires and cables in the wireways as
IMPORTANT
established in
shared-bus connection system.
Figure 59 - Capacitor Module Features and Indicators
3
2
2
1
Kinetix 5500 Capacitor Module
Front View
1
Table 43 - Capacitor Module Connector Specifications
Capacitor Module
Pin
Cat. No.
MS-1
2198-CAPMOD-1300
MS-2
Rockwell Automation Publication 2198-UM001F-EN-P - December 2015
wiring example on
Chapter 2. Connections to the DC-bus must be made with the
Kinetix 5500 Capacitor Module
Top View
Item Description
1 Ground screw (green)
4
2 Module status (MS) connector (relay output)
3 Module status indicator
5
4 DC bus (DC) connector (under cover)
5 24V control input power (CP) connector
(1) The DC-bus connector ships with a protective knock-out cover
that can be removed for use in shared-bus configurations.
(2) The shared-bus connector set for the capacitor module, catalog
number 2198-KITCON-CAP1300, is included for connection to the
upstream drive. Replacement kits are also available.
Recommended
Wire Size
Signal
2
mm (AWG)
RELAY+
0.14...1.5
(28...16)
RELAY-
page 201.
on page 158 for
(1) (2)
(2)
Strip Length Torque Value
mm (in.) N•m (lb•in)
0.22...0.25
7.0 (0.28)
(1.9...2.2)