Advertisement
WARNING! If a fuse blows, ensure it is replaced with an identical fuse type and rating.
‰
WARNING! If supply trips at consumer unit, ensure correct rating of supply and appliance. If further tripping occurs consult a
‰
qualified electrician.
DO NOT allow children to touch or to operate the heater.
8
DO NOT locate the heater below an electrical socket outlet.
8
DO NOT use the heater without the grille fitted.
8
DO NOT use the heater out of doors. These heaters are designed for indoor use only.
8
DO NOT use this heater if it has been dropped.
8
DO NOT use if there are visible signs of damage to the heater.
8
DO NOT cover heater when in use, and do not obstruct the air inlet and outlet grilles.
8
DO NOT place heater too close to yourself or any object, allow the air to circulate freely.
8
DO NOT touch the outlet grille of the heater during and immediately after use as it will be hot.
8
Children of less than 3 years should be kept away unless continuously supervised.
9
Children aged from 3 years and less than 8 years shall only switch on/off the appliance provided that it has been placed or installed in its
9
intended normal operating position and they have been given supervision or instruction concerning the use of the appliance in a safe
way and understand the hazards involved. Children aged from 3 years to less than 8 shall not plug in, regulate and clean the appliance or
perform user maintenance.
This appliance can be used by children aged from 8 years and above and persons with physical,
sensory or mental capabilities or lack
supervision or instruction concerning the use of the appliance in a safe way and
hazards involved. Children shall not play with the appliance. Cleaning and user
not be made by children without supervision.
2. INTRODUCTION
P
Powder coated metal cabinet with two ruby halogen infrared elements and chemically polished reflectors for
maximum heat emission. Adjustable thermostat control (15°C – 45°C). Soft-touch control panel with LED
display. Programmable 7-day timer function. Equipped with a tilt cutout switch for added safety. Features easy-
rolling castors (two locking). Suitable for a wide range of heating including restorative applications. Supplied
with cable and 32Amp/110V plug.
3. SPECIFICATION
Model No. ............................................................... IR14110V
Power .................................................................1200-2400W
Supply .....................................................................110V-32A
4. ASSEMBLY
4.1.
Attach the wheel sub-assemblies to the base of the heater using the bolts provided. Ensure the lockable wheels are to the rear of the heater.
4.2.
Attach the handle to the top of the heater using the bolts provided, ensuring the shaped spacers are fitted between the heater and the
handle as shown.
4.3.
Remove the front grille by unscrewing the retaining screws.
4.4.
Extract the lamps from the shipping carton.
WARNING! Never touch lamp glass directly with fingers, only touch the ceramic ends or use a soft cloth, otherwise elements could be
‰
damaged.
4.5.
Carefully insert each lamp into the two push-in side fittings with a gentle pressure.
4.6.
Check the lamps are properly located.
4.7.
Reassemble front grille.
5.
OPERATION
WARNING! DO NOT touch the top of the heater when in use as it becomes hot.
‰
WARNING! Always allow elements to cool before moving the units. Use only on a smooth even surface. Failure to do so will cause premature
‰
wear to the lamps and reduce their working life.
5.1.
The heater has a built in tilt switch safety mechanism that switches off the unit if it is tilted beyond 25° either forwards or backwards.
This prevents fire in the event of the unit being knocked over. If the unit does not turn on again when returned to the vertical, tip it
approximately 25° in the opposite direction until you hear the internal switch operate. As the heater switches on return it to the vertical
position.
WARNING! This heater is not equipped with a device to control the room temperature. DO NOT use this heater in small rooms when they
‰
are occupied by persons not capable of leaving the room on their own, unless constant supervision is provided.
5.2.
Place the heater on a level floor in the area you require to heat.
5.3.
Allow a minimum of 2m between the heater and adjacent objects.
5.4.
POWER ON/OFF
5.4.1.
Connect to mains supply turn on red rocker switch.
5.4.2.
Heater is in standby screen shows 'OF'.
5.4.3.
Press
to start heater. Screen shows: week, time, ambient
temperature and power indication.
5.4.4.
Press
again heater turns off, returns to standby screen shows 'OF'
5.5.
5.6.
SETTING TEMPERATURE
5.6.1.
Default temperature at power on is 30°C.
5.6.2.
Press
or
© Jack Sealey Limited
of experience and knowledge if they have been given
to set temperature. One press = 1°C. Screen shows temperature only. Range is 15 to 45°C.
Original Language Version
understand the
maintenance shall
IR14110V Issue:1 27/07/21
Advertisement
