Advertisement
5.9.9.
Press
to activate or deactivate the days of week working time modes. When week and time symbols are both displayed it means
the days of week working time mode is active.
5.9.10.
Repeat above procedures to change weekly working time modes timer.
5.9.11.
RESET
Enter process as far as day selection then press
only reset existing programs day by day.
5.10.
OPEN WINDOW DETECTION FUNCTION
5.10.1.
When ambient temperature drops over 5°C in 10 minutes, heater will power off automatically and sound 3 alarm beeps. Power on
again by pressing
5.11.
All set programs will be stored even if the power is off.
5.12.
Temperature is only adjustable when the days of week working time modes is inactive.
5.13.
Clock continues to work after power off. Charge battery after 12 hours of initial use (standby and working modes will both charge the
battery).
6. MAINTENANCE
WARNING! Before attempting any maintenance ensure the unit is unplugged from the mains power supply, it is cool and on level
‰
ground.
DO NOT touch the element glass, even when cold.
8
DO NOT use the heater with out the grills fitted.
8
6.1.
To clean the reflector, remove the front grill by unscrewing the retaining screws and wipe the reflector with a clean dry cloth. DO NOT
use abrasives or solvents. The surface of the reflector is very soft and scratches may cause it to overheat. Replace the grille.
6.2.
To change the element remove the front grille by unscrewing the retaining screws.
6.2.1.
Ease the sprung sockets on the ends of the element back and pull the element forward so that it clears the socket, remove element.
WARNING! Never touch element glass directly with fingers, only touch the ceramic ends or use a soft cloth, to prevent damage.
‰
6.2.2.
Carefully insert the replacement lamp into the two push in side fittings with gentle pressure.
6.3.
Check the element is properly located, then replace front grill.
6.4.
BATTERY REPLACEMENT
6.4.1.
Refer to Parts Diagram. The battery is located on the lower PCB. IT is recommended that it is replaced by a suitably qualified person.
6.4.2.
Store in a dry, child free area.
WEEE REGULATIONS
Dispose of this product at the end of its working life in compliance with the EU Directive on Waste Electrical and Electronic Equipment
(WEEE). When the product is no longer required, it must be disposed of in an environmentally protective way. Contact your local solid
waste authority for recycling information.
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
Important: No Liability is accepted for incorrect use of this product. Please note that other versions of this product are available. If you require
documentation for alternative versions, please email or call our technical team on technical@sealey.co.uk or 01284 757505.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500
© Jack Sealey Limited
for 3 seconds, all existing set programs for that day will be deleted. Users can
01284 703534
sales@sealey.co.uk
Original Language Version
www.sealey.co.uk
IR14110V Issue:1 27/07/21
Advertisement
