Unit Removal - Sanyo FXD-RS50 Operating Instructions Manual

Power Wire Harness
X1
INSTALLATION
1. BEFORE INSTALLATION
When mounting the unit in a car, keep the unit as level as possible.
If the unit must be mounted at an angle, due to the design of the vehicle, make sure the unit
does not tilt by more than 30
2. INSTALLATION PROCEDURES
When mounting the unit into a DIN–standard cutout (182x53 mm) in the dashboard or console,
attach the provided Removable Trim Ring to the unit.
1. Insert the mounting bracket into the DIN-standard cutout (182x53 mm) in the dashboard or
console.
2. Bend the mounting bracket stopper outward until the bracket fits snugly in the cutout.
3. Attaching the Mounting Strap to the underside of the dashboard, using screw. Attach the
back of the unit to the Mounting Strap using support stem bolt and hardware.

UNIT REMOVAL

1. Insert the unlock levers into the slots on each side of the unit until they click into place.
2. Pull the levers to remove the unit.
Notes
• Handle the unlock levers carefully to avoid injuring your fingers.
• Keep the unlock levers in a safe place for future use.
Speaker Wire Harness
X1
0
.
16
CD Change Wire Socket
X1