multicomp pro MP720644 User Manual page 130

Performance Characteristics
Interpolation
Max Record length
Scanning speed (S/div) 2ns/div - 1000s/div, step by 1 – 2 - 5
Sampling rate / relay
time accuracy
Interval(△T) accuracy
(DC - 100MHz)
Sensitivity
Displacement
Analog bandwidth
Single bandwidth
Low Frequency
Vertical system
Rise time (at input,
Typical)
DC gain accuracy
DC accuracy (average)
Waveform inverted ON/OFF
Cursor
Automatic
Measurement
Waveform Math
Multicomp-Pro user Manual
When two channels are turned on, the max
record length is 20M; and max 40M for one
channel.
±10 ppm max (Ta = +25℃)
Single:
±(1 interval time+1 ppm×reading+0.6 ns);
Average>16:
±(1 interval time +1 ppm×reading+0.4 ns)
1 mV/div - 10 V/div
±2 V (1 mV/div – 50 mV/div);
±20 V (100 mV/div – 1 V/div);
±200 V (2 V/div – 10 V/div)
100 MHz
DC to 100 MHz
≥10 Hz (at input, AC coupling, -3 dB)
≤ 3.5 ns
≥2 mV
Delta Volts between any two averages of ≥16
waveforms acquired with the same scope
setup and ambient conditions (△V):
±(3% rdg + 0.05 div)
△V, △T, △T&△V between cursors,
auto cursor
Period, Frequency, Mean, PK-PK, RMS, Max,
Min, Top, Base, Amplitude, Overshoot,
Preshoot, Rise Time, Fall Time, +Pulse
Width, -Pulse Width, +Duty Cycle, -Duty
Cycle, Delay A→B
RMS, Cursor RMS, Screen Duty, FRR, FRF,
FFR, FFF, LRR, LRF, LFR, LFF, Phase
A→B
-Pulse Count, Rise Edge Count, Fall Edge
Count, Area, and Cycle Area.
＋, －, *, / ,FFT, FFTrms, Intg, Diff, Sqrt, User
Defined Function, digital filter (low pass, high
pass, band pass, band reject)
126
Instruction
(Sinx)/x, x
±3%
, Delay A→B
, Phase A→B , +Pulse Count,
, Cycle