inVue OneKEY Manual page 3

The LED on the back of the OneKEY
7b
Manager will illuminate, indicating that
it is receiving power.
Select "Yes" to proceed and enter
9 9
your OKM Installer Code.
Select "No" if not using Access
Mananger.
Plug the network cable into the eth-
7c
ernet port on the OneKEY Manager.
Follow the screen prompts to set up
the OKM
Note: If not using Access Manager, it
is not necessary to connect the OKM
to the internet.
Enter your OKM Installer Code.
10 10
Select the Language. Confirm by
8 8
pressing "Yes".
Note: Not all languages may be
supported at the time of launch.
Additional languages will be added
through periodic updates.
Select which option best suits your
11 11
installation
• Auto Connect (DHCP) - Best suited
for most installations
• Manual Connect (Static IP) - Will
need to be coordinated between your
IT department and InVue Customer
Service
• Proceed without Connection -
Select this is not using Access
Manager and not connected via
ethernet.
Section 3: Enrolling the OneKEY
Manager (OKM) in Access
Manager
Before beginning, ensure that you have a valid
InVue Access Manager account and
the following information
• Your Site URL
(for example "https://customer.invue-am.com")
• Your Manager PIN
• Your Administrator User Name & Password
• Your Adminstrator User Pin
• Your OKM Installer Code (not needed if
using the OKM without Access Manager).
• The TCP port for the OKM
If you do not have any of these credetials, please
reach out to the InVue Customer Service Team.
• NA / LATAM // 704.752.6513 • 888.55.INVUE
• EMEA // +31.23.8900150
• APAC // +852.3127.6811
The OKM will display a connection
12 12
status screen.