Checking Lamp Usage; Replacing The Batteries - Epson PowerLite G5000 User Manual

note
The information displayed
depends on the input signal
currently selected.
caution
When replacing batteries,
take the following
precautions:
■ Replace the batteries as
soon as they run out. If the
batteries leak, wipe away
battery fluid with a soft
cloth. If fluid gets on your
hands, wash them
immediately.
■ Do not expose batteries to
heat or flame.
■
Dispose of used batteries
according to local
regulations.
■
Do not use batteries other
than those specified in this
User's Guide and do not
use batteries of different
types or mix old and new
batteries.
■
Keep these batteries out of
the reach of children.
Batteries are choking
hazards and are very
dangerous if swallowed.
Maintaining the Projector
78

Checking Lamp Usage

To check the number of hours the lamp has been used, press the
button and highlight the
Menu
The life span of the lamp is about 2000 hours if the
setting in the Settings menu is set to
Control
3000 hours if the
Brightness Control
sure you have a spare lamp handy if the usage hours on this menu are
close to the life span of your lamp.

Replacing the Batteries

Replace the batteries in the remote control as described below:
1. Turn the remote control over.
2. Press down on the tab on the
battery cover as you lift the cover
off.
menu. You see a screen like this:
Info
Brightness
(default), and
High
setting is set to . Make
Low