Epson PowerLite G5000 User Manual page 60

note
If a power outage occurs
when Direct Power On is
enabled and the power cord
is connected, the projector
will start when the power is
restored.
Do not use the projector at
altitudes above 7,500 feet
(2,286 meters).
Fine-Tuning the Projector
60
■ Operation
Enable
Direct Power On
projector when you connect the power cord (without pressing the
Ppower button). Enable
to turn off automatically if it is idle (and no signal is received) for
10 minutes (you can adjust the amount of time using the
setting). Enable
Mode Timer
using the projector above 4,900 feet (1,500 meters).
■
Standby Mode
Select
Network On
network when it is in standby mode (the power light is orange).
■ Projector ID
Lets you assign a numeric ID to each projector. When you are
using multiple projectors, you can use the ID to select the one you
want to operate with the remote control. See page 43 for
instructions.
■
Multi-screen
Use this option if you want to color-match two or more projectors
that are being used to display images near each other. You can
make image adjustments at each of five adjustment levels. First
choose an
Adjustment Level
each level:
Brightness Correct
to adjust the balance between red and green, or
Color Correct
blue and yellow. See page 61 for more information about
multi-screen color adjustment.
■ Language
Select from 27 languages to be used for the projector menus.
if you want to be able to start the
if you want the projector
Sleep Mode
High Altitude Mode
to enable monitoring of the projector over a
and then adjust the settings for
to adjust the brightness, and
Sleep
when you are