Table of Contents
Advertisement
■
Never open any covers on the projector except as specifically explained
in this User's Guide. Never attempt to disassemble or modify the
projector (including consumables). Refer all repairs to qualified service
personnel.
■
Use the type of power source indicated on the projector. Use of a
different power source may result in fire or electric shock. If you are not
sure of the power available, consult your dealer or power company.
■
If you use the projector in a country other than where you purchased it,
use the correct power cord for that country.
■
Take the following precautions when handling the plug: Do not hold
the plug with wet hands. Do not insert the plug into a dusty outlet.
Insert the plug firmly into the outlet. Do not pull the power cord when
disconnecting the plug; always be sure to hold the plug when
disconnecting it. Do not overload wall outlets, extension cords, or power
strips. Failure to comply with these precautions could result in fire or
electric shock.
■
Do not place the projector where the cord can be walked on.
■
The lamp(s) in this product contain mercury. Please consult your
state and local regulations regarding disposal or recycling. Do not put in
the trash.
■
Do not place anything that can become warped or damaged by heat near
the exhaust vents. Do not bring your hands or face close to the vents
while projection is in progress.
■
Before you move the projector, make sure its power is turned off, the
plug is disconnected from the outlet, and all cables are disconnected.
■
Never try to remove the lamp immediately after use because it will be
extremely hot. Before removing the lamp, turn off the power and wait at
least an hour to allow the lamp to cool completely.
■
Do not place the source of an open flame, such as a lit candle, on or near
the projector.
■
Do not modify the power cord. Do not place heavy objects on top of the
power cord or bend, twist, or pull it excessively. Keep the power cord
away from hot electrical appliances.
■
If the lamp breaks, ventilate the room to prevent gases contained in the
lamp from being inhaled or coming in contact with the eyes or mouth.
■
If the projector is mounted overhead and the lamp breaks, be careful to
prevent pieces of glass from falling into your eyes or mouth when you
open the lamp cover.
■
Do not disassemble or damage the lamp or subject it to any impacts.
■
Do not bring your face close the projector while it is in use.
Notices
161
Advertisement
Table of Contents
