Table of Contents
Advertisement
Using the Projector on a Network
66
7. Choose
IP Settings
following:
8. Do one of the following:
■
If your network assigns addresses automatically, turn on the
setting.
DHCP
■
If your network does not assign addresses automatically, turn
off
and enter the projector's
DHCP
, and
Mask
Gateway Address
To enter numbers, use the
control to highlight the number you want to input, then press
the
button. When you're finished entering an address
Enter
in the network menu, highlight
button.
9. To prevent the IP address from appearing on the standby screen,
set the
IP Address Display
10. When you're done making these settings, highlight the
button at the top of the screen, then press
and press
Complete
save your settings.
Press
to exit the menu system.
Menu
and press
. You see a screen like the
Enter
IP Address
, as needed.
buttons on the remote
Return
setting to
.
Off
Enter
, then choose
Enter
Yes
,
Subnet
, then press the
Enter
Return
. Choose
and press
to
Enter
Advertisement
Table of Contents
