Shutting Down The Projector - Epson PowerLite 7800p User Manual

Shutting Down the Projector

When you've finished using the projector, follow the recommended
procedure to shut it down. This extends the life of the lamp and
protects the projector from possible overheating.
1. Turn off and disconnect any equipment plugged into the
projector.
2. To turn off the projector, press the red P
projector or remote control.
You see a confirmation message. (If you don't want to turn it off,
press any other button.)
3. Press the button again. The power light flashes orange for
Power
about 30 seconds as the projector cools down. After the projector
has cooled, the orange light stays on and the exhaust fan shuts off.
If you want to turn the projector on again, wait until the orange
light stops flashing. Then press the
4. If you extended the adjustable front foot, press up on the blue
foot release lever to retract it.
5. Replace the lens cap and unplug the power cord.
6. If you're using a remote control, set its on/off switch to
conserves battery power.
button on the
Power
Power button
button.
Power
OFF
Displaying and Adjusting the Image
note
When the projector has not
received any input signals
for 30 minutes, it
automatically turns off the
projector lamp and enters
"sleep mode." This conserves
electricity, cools the
projector, and extends the
life of the lamp. If you want
to start projecting again,
press the
Power
you are done using the
projector, unplug the power
cord. To turn off sleep mode,
see page 74.
Power OFF? Power OFF?
Yes : : Press Yes Press
No : : Press any other button No Press any other button
caution
To avoid damaging the
projector or lamp, never
unplug the power cord when
the power light is green or
flashing orange.
. This
button. If
button button
43