Solving Easy Management Problems; Solving Problems With The Remote Control - Epson PowerLite 7800p User Manual

Solving Problems
112

Solving Easy Management Problems

You don't see your projector in the EMP Monitor window.
■ Make sure that you've connected the projector to the network and
configured it correctly; see page 78. Also, make sure you've
registered the projector with EMP Monitor. See page 81.
Make sure that Standby Mode in the Advanced1 menu is set to
■
.
Network ON
If the computer you are using is running Windows XP, 2000, or
■
NT 4.x, you must be logged in as the Administrator.
Try restarting your computer.
■
Solving Problems with the Remote
Control
The projector doesn't respond to remote control commands.
If you're using the remote control for the first time, be sure to
■
push up on the on/off switch, as shown on page 46.
The remote control's battery may not be installed correctly or may
■
be low on power. To change the battery, see page 48.
Make sure your remote control's ID is set to 0, or to the
■
projector's ID. See page 61.
■ Make sure you are within 33 feet (10 meters) of the projector, and
within range of the projector's front or back sensor
(approximately 30° to the left or right and 15° above or below).
Dim the room lights and turn off any fluorescent lights. Make
■
sure the projector is not in direct sunlight. Strong lighting,
especially fluorescent lights, may affect the projector's infrared
receivers. Also, turn off any nearby equipment that emits infrared
energy, such as a radiant room heater.