Table of Contents
Advertisement
MAINTENANCE PROCEDURE
Items to be prepared
•
Container to catch drained oil
1.
Remove inspection window (1) of the undercover.
2.
Place a container under drain plug (P) to catch the oil.
3.
Remove drain plug (P) and drain the oil.
Loosen drain plug (P) gradually so that the oil will not
spout out, and then remove it.
4.
After draining the oil, install drain plug (P).
Tightening torque: 68.6 ± 9.8 Nm {7.0 ± 1.0 kgm}
5.
Remove bolts (2) (4 pieces) and move tube (3).
6.
Remove strainer (4).
7.
Remove all dirt from strainer (4), then wash it in clean die-
sel fuel or flushing oil.
If strainer (4) is damaged, replace it with a new one.
8.
Install strainer (4) to the case.
Replace O-ring of tube (3) with a new one and install tube
(3).
9.
Add the refill capacity of oil through oil filler port (F).
10. After adding oil, check that the oil level is proper. For de-
tails, see "METHOD FOR CHECKING OIL LEVEL IN
TRANSMISSION CASE, ADDING OIL (4-23)".
11. Check the transmission case for oil leakage.
METHOD FOR REPLACING TRANSMISSION OIL FILTER CARTRIDGE
Immediately after the engine is stopped, its parts and oil are still very hot and may cause burn injury.
Wait for the temperature to go down, and then start the work.
Items to be prepared
•
Container to catch drained oil
•
Filter wrench
4-54
k
k
WARNING
MAINTENANCE
Advertisement
Chapters
Table of Contents
