Wallbeds Australia AB-4b Assembly Instructions Manual page 4

Cam Pins Insert all Cam Locks into the following panels as described by the cabinet part located

on the cabinet sticker.

End Panel

Drawer Front

Attach the runners prior to assembling the cabinetry.

Drawer Runners –

Line up the holes in the metal runner with the pre-drilled holes in the End Panel. Attach these

runners using the Euro screws. Do this for both End Panels - Refer to images 7 & 8 page 10

Pull Out Drawer / Table Runners –

Turn the runner over to view from the back. Detach the drawer slide from the main

sliding runner by pulling the clip as indicated by the arrow on the clip. Refer image

14 page 12. Line up the three holes in the metal runner with the pre-drilled holes in

the End Panel. Attach these runners using the Euro screws. Refer image 15 page

12. Repeat for the remaining End Panel.

DO NOT re-insert the drawer / table slide at this stage.

Drawer Clips –

Insert these into the drawer front ensuring the up & down arrows on the drawer clips are facing

the outside edge of the drawer panel.

Fix these into the drawer front by tapping them in gently with a hammer - Refer image 11 page 11

End Panel

Drw Bot

Bottom Panel

NOTE: In the

Bottom Panel Insert

the cam pins on the

opposite side to the

Cam Lock.

Pull Out Drawer /Table Front

Top Panel

NOTE: In the Top

Panel Insert the cam

pins on the same

side as the Cam

Lock