Dell EMC PowerEdge R730xd Owner's Manual page 134

telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that are shipped with your product.
To use an SD card with your system, ensure that the Internal SD Card Port is enabled in System Setup.
NOTE:
Temporarily label each SD card with its corresponding slot number before removal. Re-install the SD card(s) into the
NOTE:
corresponding slots.
Steps
1. Locate the SD card connector on the internal dual SD module. Orient the SD card appropriately and insert the contact-pin
end of the card into the slot.
The slot is keyed to ensure correct insertion of the card.
NOTE:
2. Press the card into the card slot to lock it into place.
Figure 70. Installing an internal SD card
1. IDSDM
3. SD card 1
5. SD card slot 2
Next steps
Follow the procedure listed in the After working inside your system section.
Related references
Safety instructions on page 67
Related tasks
Before working inside your system
After working inside your system
134 Installing and removing system components
on page 68
on page 68
2. SD card 2
4. SD card slot 1