Installing The Riser 1 Blank - Dell EMC PowerEdge R730xd Owner's Manual

Installing the riser 1 blank

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that are shipped with your product.
Steps
To install the riser 1 blank, align the blank with the slot on the chassis and insert it into the chassis until it clicks into place.
Figure 59. Installing the riser 1 blank
a. slot on the chassis
b. tab (2)
c. riser 1 blank
Next steps
1. Install the expansion card risers.
2. Follow the procedure listed in the After working inside your system section.
Related references
Safety instructions on page 67
Related tasks
Before working inside your system
Removing expansion card risers
Installing expansion card risers
After working inside your system
126 Installing and removing system components
on page 68
on page 127
on page 130
on page 68