Diagnostic Indicators On The Front Panel - Dell EMC PowerEdge R730xd Owner's Manual

Table 4. Back panel features (continued)
Item Indicator, button, or
connector
2 System identification
connector
3 iDRAC8 Enterprise port
4 Half-height PCIe expansion
card slot (3)
5 Serial connector
6 Video connector
7 USB port (2)
8
Full-height PCIe expansion
card slot (3)
9 Ethernet connector (4)
10 Power supply unit (PSU1)
11 Power supply unit (PSU2)
12
vFlash media card slot
13
Hard drive (2) (back)

Diagnostic indicators on the front panel

No diagnostic indicators are lit when the system is turned off. To start the system, plug it into a working power
NOTE:
source and press the power button.
Icon Description
When one of these buttons is pressed, the system status
indicator on the back flashes until one of the buttons is
pressed again.
Press to toggle the system identification (ID) on or off.
If the system stops responding during POST, press and hold
the system ID button for more than five seconds to enter
BIOS progress mode.
To reset iDRAC (if not disabled in F2 iDRAC setup) press and
hold the button for more than 15 seconds.
Connects the optional system status indicator assembly
through the optional cable management arm.
Dedicated management port.
Enables you to connect up to three half-height PCI Express
expansion cards.
Enables you to connect a serial device to the system.
Enables you to connect a VGA display to the system.
Enables you to connect USB devices to the system. The ports
are USB 3.0-compliant.
Enables you to connect up to three full-height PCI Express
expansion cards.
Four integrated 10/100/1000 Mbps Network Interface Card
(NIC) connectors
or
Four integrated connectors that include:
● Two 10/100/1000 Mbps NIC connectors
● Two 100 Mbps/1 Gbps/10 Gbps SFP+/10 GbE T
connectors
AC
or
DC
Enables you to insert a vFlash media card.
Up to two hot-swappable 2.5-inch hard drives.
495 W, 750 W, or 1100 W
750 W or 1100 W
Dell PowerEdge R730xd system overview 15