Removing The I/O Panel - Dell EMC PowerEdge R730xd Owner's Manual

Figure 125. Installing the control panel
1. screw (3)
3. hard-drive backplane
5. plastic pull tab
Next steps
Follow the procedure listed in the After working inside your system section.
Related references
Safety instructions on page 67
Related tasks
Before working inside your system
After working inside your system

Removing the I/O panel

Prerequisites
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. Keep the T15 Torx screwdriver ready.
CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that are shipped with your product.
CAUTION: To prevent damage to the I/O cable, you must release the locking tab before removing or installing
the I/O cable from the connector on the hard drive backplane.
on page 68
on page 68
2. control panel
4. connector
Installing and removing system components 191