System Battery; Replacing The System Battery - Dell EMC PowerEdge R730xd Owner's Manual

Related tasks
Before working inside your system
After working inside your system

System battery

The system battery is used to power the real-time clock and storing the BIOS settings of the system.

Replacing the system battery

Prerequisites
There is a danger of a new battery exploding if it is incorrectly installed. Replace the battery only with the same or
NOTE:
equivalent type recommended by the manufacturer. For more information, see the safety information that shipped with your
system.
CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that are shipped with your product.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. Remove the cooling shroud.
Steps
1. Locate the battery socket. For more information, see the Jumpers and connectors section.
CAUTION: To avoid damage to the battery connector, you must firmly support the connector while installing
or removing a battery.
2. Place your finger between the securing tabs at the negative side of the battery connector, and lift the battery out of the
socket.
Figure 76. Removing the system battery
a. system battery
b. system battery slot
3. To install a new system battery, hold the battery with the "+" facing up and slide it under the securing tabs.
4. Press the battery into the connector until it snaps into place.
on page 68
on page 68
Installing and removing system components 141