Ricoh Aficio SP 320 Series User Manual page 195

Item
Address Settings
Action
Status
To configure IPsec policies, select the desired IPsec policy, and then click [Change] to open the "IPsec
Policy Settings" page. The following settings can be made on the "IPsec Policy Settings" page.
IP Policy Settings
Item
No.
Activity
Name
Address Type
Local Address
Remote Address
Prefix Length
Displays the IP address filter of the IPsec policy as below:
Remote address/Prefix length
Displays the action of the IPsec policy as "Allow", "Drop", or "Require
Security".
Displays the status of the IPsec policy as "Active" or "Inactive".
Specify a number between 1 and 10 for the IPsec policy. The number you
specify will determine the position of the policy in the IPsec Policy List. Policy
searching is performed according to the order of the list. If the number you
specify is already assigned to another policy, the policy you are
configuring will take the number of the earlier policy, and the earlier policy
and any subsequent policies will be renumbered accordingly.
Select whether to enable or disable the policy.
Enter the name of the policy. Can contain up to 16 characters.
Select IPv4 or IPv6 as the type of IP address to be used in IPsec
communication.
Displays the IP address of this printer.
Enter the IPv4 or IPv6 address of the device with which to communicate.
Can contain up to 39 characters.
Enter the prefix length of the Remote Address, using a value between 1 and
128. If this setting is left blank, "32" (IPv4) or "128" (IPv6) will be
automatically selected.
Configuring the IPsec Settings
Description
Description
193