Inquiries - ABB ACS800 Hardware Manual

Unpack and check the units.
Check that all necessary optional modules and
equipment are present and correct.
Only intact units may be started up.
Check the installation site.
If the drive is about to be connected to an IT
(ungrounded) system, check that the drive is not
equipped with EMC filter +E202.
Route the cables.
Check the insulation of the motor and the motor
cable.
Install the drive. Connect the power cables. Connect
the control and the auxiliary control cables.
Commission the drive.
Commission the optional brake chopper (if present).
Operating of the drive: start, stop, speed control etc.

Inquiries

Address any inquiries about the product to the local ABB representative, quoting the
type code and serial number of the unit. If the local ABB representative cannot be
contacted, address inquiries to the manufacturing facility.
Task See
If the converter has been non-operational for
more than one year, the converter DC link
capacitors need to be reformed. Ask ABB for
instructions.
Technical data
The ACS800-04/U4 and ACS800-04M:
code. For instructions on how to disconnect the
EMC filtering, contact ABB.
Planning the electrical installation:
cables
Electrical installation: Checking the insulation of
the assembly
Electrical installation, Resistor braking
(optional)
Appropriate firmware manual
Resistor braking
Appropriate firmware manual
21
Type
Routing the
About this manual