A Projector Cannot Be Monitored Or Controlled Using Emp Monitor - Epson EMP-6100 Operation Manual

A projector cannot be monitored or controlled using EMP Monitor

Cause
Is the projector connected to
the network correctly?
Has the projector been set
up correctly for connection
to the network?
Has EMP Monitor been
installed to the computer
correctly?
Have all projectors that are
to be monitored and
controlled been registered in
the projector list?
Is the projector's "Network
Monitoring" or "Standby
Mode" configuration menu
set to "ON" or "Network
ON"?
Remedy
Connect the network cable correctly.
s"Network Cable Connections" in the
accessory User's Guide
Check the settings for the "Network"
configuration menu command.
sAccessory User's Guide
Uninstall EMP Monitor and then re-install
it.
Register the projector in the projector list.
sp.4
In order to use EMP Monitor to monitor
and control the projector when it is in
standby mode, the projector's "Network
Monitoring" or "Standby Mode"
configuration menu must be set to "ON" or
"Network ON".
sAccessory User's Guide
11