When A Connection Is Made Using Easymp Network Projection, The Projected; Cannot Select Or Change The Connection Mode; The Screen Is Not Projected; The Slide Show Cannot Be Displayed On The Desired Display When The Multi-Screen Display Function Is Being Executed - Epson EasyMP Network Projection Operation Manual

Multimedia projector

Hide thumbs Also See for EasyMP Network Projection:

Table of Contents

Troubleshooting

When a connection is made using EasyMP Network Projection, the projected image remains as it is, and a connection cannot be made

from another computer.

Check

Did the presenter leave the conference room without cutting off the

network connection?

Check

Is EasyMP Network Projection set to start up using the same

connection mode?

Check

Are you using PowerPoint 2002 or an earlier version?

(For Windows)

Check

Is another application running on the virtual display

(For Windows)

With EasyMP Network Projection, the computer currently connected can be disconnected when another computer

tries to connect to the projector.

Therefore, when a Projector Keyword is not set for the projector, or if you know the Projector Keyword, you can

disconnect the computer currently connected and then connect your computer to the projector.

When a Projector Keyword is set for the projector and you do not know the Projector Keyword, restart the projector

and reconnect.

Select Display Connection Mode Selection window on startup on the General settings tab from Set options. The

projector selection screen is displayed after restarting EasyMP Network Projection.

To set and use two or more virtual displays

one before displaying the Slide Show.

When EPSON Virtual Display is installed, another application sometimes runs on the virtual display. In this case, set

EPSON Virtual Display to off in Screen properties.

Remedy

, use PowerPoint 2003 or later, or limit the number of virtual displays to

Remedy

Table of Contents