When A Connection Is Made Using Easymp Network Projection, The Projected; Cannot Select Or Change The Connection Mode; The Screen Is Not Projected; The Slide Show Cannot Be Displayed On The Desired Display When The Multi-Screen Display Function Is Being Executed - Epson EasyMP Network Projection Operation Manual

Troubleshooting
Check
Are the access point and the projector's subnet different?
(For Advanced Connection Mode)
Have you enabled DHCP?
(For Advanced Connection Mode)
When a connection is made using EasyMP Network Projection, the projected image remains as it is, and a connection cannot be made
from another computer.
Check
Did the presenter leave the conference room without cutting off the
network connection?

Cannot select or change the connection mode.

Check
Is EasyMP Network Projection set to start up using the same
connection mode?

The screen is not projected.

The Slide Show cannot be displayed on the desired display when the multi-screen display function is being executed.

Check
Are you using PowerPoint 2002 or an earlier version?
(For Windows)
Select Manual search from EasyMP Network Projection, specify the IP address, and connect.
s "Specifying Either an IP Address or Projector Name and Performing a Search (Advanced Connection Mode
Only)" p.17
When DHCP is set to On in Advanced Connection Mode, it may take some time to enter LAN standby status if an
available DHCP server is not found.
With EasyMP Network Projection, the computer currently connected can be disconnected when another computer
tries to connect to the projector.
Therefore, when a Projector Keyword is not set for the projector, or if you know the Projector Keyword, you can
disconnect the computer currently connected and then connect your computer to the projector.
When a Projector Keyword is set for the projector and you do not know the Projector Keyword, restart the projector
and reconnect.
Select Display Connection Mode Selection window on startup on the General settings tab from Set options. The
projector selection screen is displayed after restarting EasyMP Network Projection.
To set and use two or more virtual displays
one before displaying the Slide Show.
Remedy
Remedy
Remedy
Remedy
g
, use PowerPoint 2003 or later, or limit the number of virtual displays to
44