Huawei AP4050DN-E Hardware Installation And Maintenance Manual page 58

AP4050DN-E
Hardware Installation and Maintenance Guide
Step 4 Crimp the joint parts of the bare crimping terminal and the conductor, as shown in
5-25.
Figure 5-25 Crimping the joint parts of the bare crimping terminal and the conductor (OT
terminal)
Step 5 Push the heat shrink tubing (A) toward the connector until the tube covers the crimped part,
and then use a heat gun to heat the tube, as shown in
Figure 5-26 Heating the heat shrink tubing (OT terminal)
Stop heating the shrink tubing when the connector is securely locked in the shrink tubing. Do
not heat the shrink tubing too long as this may damage the insulation coating.
----End
Issue 05 (2018-02-02)
NOTE
The shapes of crimped parts may vary with the crimping dies.
NOTICE
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Figure 5-26.
5 Appendix
Figure
50