Huawei AP4050DN-E Hardware Installation And Maintenance Manual page 51

AP4050DN-E
Hardware Installation and Maintenance Guide
Figure 5-13 Correct operation for replacing a clamping jaw
1. Groove
Step 2 Reserve the cable length at the assembly end, bind the plastic cable tie, install the nut,
clamping jaw, and socket on the cable and pre-tighten them, as shown in
Figure 5-14 Pre-tightening
1. Cable
Step 3 Use the stripping ruler card to measure required lengths, strip the outer jacket (48 mm) on the
head of the cable to be connected and the outer jacket (17 mm) of each core wire, twist the
shield layers into one strand, as shown in
l
l
l
l
Issue 05 (2018-02-02)
NOTICE
The stripping ruler card is delivered with the components of the connector.
Cut the padding using diagonal pliers.
Gently strip the insulation sheath to avoid damage to the conductor metal.
Ensure that the edge of core wires is not split.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2. Boss
2. Plastic cable tie
Figure 5-15.
5 Appendix
Figure 5-14.
43