Huawei AP4050DN-E Hardware Installation And Maintenance Manual page 20

AP4050DN-E
Hardware Installation and Maintenance Guide
4.
5.
Two-Cable per Card
In this mode, only one RFID card can be installed. The card1 slot is preferentially used.
1.
Issue 05 (2018-02-02)
3
1
2
1. AP4050DN-E
Install RF cables and sort cables following the instruction shown in the figure.
NOTE
l The diagonal size of a hexagon SMA connector must be less than or equal to 8 mm; otherwise, the
cable cannot be installed.
Slide the cover back.
Remove the front cover of an AP.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2. IoT card
2 AP Installation
3. M2x7 screws
12