Huawei AP4050DN-E Hardware Installation And Maintenance Manual page 123

AP4050DN-E
Hardware Installation and Maintenance Guide
Figure 5-148 Installing a new mold in the COAX crimping tool
Keep the short side of the mold inwards and the long side outwards, with the teeth of the mold
aligning from the larger size to the smaller size.
Step 5 Hold the handles of the COAX crimping tools tightly to match the mold and the jaw
completely. Align the screw holes, as shown in
Figure 5-149 Aligning the screw holes
Step 6 Hold the handles of the COAX crimping tools with one hand. Tighten the two fastening
screws clockwise.
crimping tool.
Issue 05 (2018-02-02)
NOTICE
Figure 5-150
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Figure 5-149.
and Figure 5-151shows the mold installed in the COAX
5 Appendix
115