Server Software Installation; Installing The Fiery Spark Server Software - Epson Stylus Pro 10000 Installation Manual

4 | Installation Guide

Server Software Installation

Before you begin, make sure you've:
Connected the printer to the server
•
Installed the EPSON printer driver (see your EPSON printer
•
documentation for instructions)
Installed the IEEE-1394 driver if you're using the EPSON Stylus
•
Pro 10000 (the driver is on the CD-ROM that came with your printer; for
installation instructions, see the Product Support Bulletin at
http://support.epson.com)
Closed all open programs and turned off any virus protection programs.
•
Use a short server name (8 characters or less). Otherwise, you won't
Note
be able to see the server name and print queue in the Chooser on
Macintosh clients.
Do not install the hardware key until after all the software is installed.
Install the following software on the server:
Fiery Spark Server software (see below)
•
Command WorkStation (page 5)
•

Installing the Fiery Spark Server Software

Follow these steps:
1. Insert the Fiery Spark System Software CD-ROM in your CD-ROM or
DVD drive.
2. Double-click
icon.
3. Double-click the
4. Follow the on-screen instructions.
, then double-click the
My Computer
icon in Fiery folder, then click
Setup
CD-ROM
.
Next