Installing The Server Software; Assigning A Static Ip Address - Epson Stylus Pro 10000 Quick Installation Manual

Installing the Server Software

Follow the instructions in this section to install the software on the server.
They describe how to:
Assign a static IP address (see below)
•
Name the server (see page 6)
•
Install the Fiery Spark Server software (see page 6)
•
Connect the hardware key (page 7)
•
Install Command WorkStation
•
Install ColorWise Pro Tools (optional, see page 11)
•
Before you begin, make sure you have:
Installed the EPSON printer driver (see your EPSON printer
•
documentation for instructions)
Connected the printer to the server using the USB interface (Stylus Pro
•
7600 and 9600) or the FireWire IEEE 1394 interface (Stylus Pro 10000
and 10600)
Closed all open programs and turned off any virus protection programs
•

Assigning a Static IP Address

1. Right-click
My Network Places
2. Select
Properties
3. Right-click
Local Area Connection
4. Select
Properties
5. Double-click
If the server is using a DHCP connection, skip ahead to "Naming the
Server" on page 6.
.
.
Internet Protocol (TCP/IP
Assigning a Static IP Address
™ (see page 8)
.
.
).
| 5