Trane Symbio 210 Installation, Operation And Maintenance Manual page 30

Controller LEDs
Each of the following codes is a two digit number following this pattern: First digit, 600mS pause,
Second digit, 2 second pause and then repeat the pattern.
Table 10. Marquee LED status and error codes
LED Blink Pattern
Solid green light
11
13
14
16
17
23
28
29
33
35
36
Green LED Blink 37
Pattern
38
41
43
45
46
47
51
52
53
55
56
58
61
63
30
Message
No active alarms or
messages
Attempting to load the field kernel and device
Load Field
tree from NAND flash.
Successfully loaded the filed images and are
Boot Field
attempting to boot.
Attempting to load the recover image from
Load Recover
NAND flash.
Successfully loaded the recovery image and
Boot Recover
are attempting to boot.
Successfully booted into the recovery
Recovery
partition.
Field Format Reformatting the field file system.
Starting Update Starting the firmware update process.
Locating Firmware File Attempting to locate a firmware update file. None- normal operation
Validating the signature on the firmware
Validating Firmware
update file.
Decrypting Firmware Decrypting the firmware update file.
Update Success Done performing the firmware update.
Clearing Database Clearing the database.
Validating the signature on the firmware
Validating Firmware
update file.
Decrypting Firmware Decrypting the firmware update file.
Restoring Backup Restoring a database backup.
The user has 30 seconds to set the rotaries to
Force Database Clear something other than 9-9-9 to start the
process of returning to factory defaults.
Done returning the database to factory
Clear Done
defaults.
Done returning whatever process was started
Done
(usually a forced recovery partition update).
Backup Retored Database backup has been restored.
Updating Firmware Updating the firmware.
Firmware Updated Firmware was updated.
Updating Firmware Firmware is currently being updated.
Updating Kernel The kernel is currently being updated.
Updating Device Tree The kernel is currently being updated.
Updating Bootloader The bootloader is being updated.
Updating Recovery The recovery file system is being updated.
Description
None- normal operation
None- normal operation
Action by User
None - normal operation
None- normal operation
None- normal operation
None- normal operation
None- normal operation
None- normal operation
None- normal operation
None- normal operation
None- normal operation
None- normal operation
None- normal operation
None- normal operation
None- normal operation
None- normal operation
None- normal operation
None- normal operation
None- normal operation
None- normal operation
None- normal operation
None- normal operation
None- normal operation
None- normal operation
None- normal operation
None- normal operation
BAS-SVX084A-EN