Applied Standards And Directives - Eaton XV100 Manual

9.8

Applied standards and directives

Property
EMC (relevant for CE)
IEC/EN 61000-6-2
IEC/EN 61000-6-4
IEC/EN 61000-6-3
5.7" devices only without cable at the USB

host and USB device interfaces
Does not apply to devices with a Smart-

Wire-DT master interface
EMC (for marine approvals)
2004/30/EU
Explosion protection (relevant for CE)
ATEX 94/9/EG: Zone 22, Category 3D (II 3D Ex tc IIIC T70°C IP6x):
IEC/EN 60079-0
IEC/EN 60079-31
safety
IEC/EN 60950
UL 60950 (only 3.5" devices)
UL 508
Product standards
EN 50178
IEC/EN 61131-2
Tab. 40 Applied standards and directives
Fig.. 43 Ethernet cable, double loop through ferrite
Touch display XV-102 10/2020 MN04802004Z-EN Eaton.com
9.8 Applied standards and directives
XV-102
Interference immunity for industrial environments
Emitted interference for industrial environments
Devices meeting this standard may not be used in
residential areas
Interference immunity for residential areas, commer-
cial and light industrial areas as well as small busi-
nesses
Ethernet cable with double loop through ferrite.
See Fig. 40 as per table
Electromagnetic Compatibility (EMC) Directive
Explosive atmospheres: Equipment - General
requirements
Explosive atmospheres: Equipment dust ignition
protection by enclosure "t"
Safety of Information Technology Equipment
Industrial Control Equipment
(technical conditions for acceptance by UL 
Chapter 5.2.1,  23)
Electronic equipment for use in power installations
Programmable logic controllers: Equipment require-
ments and tests
9 Technical data
75