Inserting And Removing The Sd Card - Eaton XV100 Manual

6.4

Inserting and removing the SD card

Fig.. 39 SD Slot (A)
CAUTION
Data loss
During a write operation, the SD card may lose data or may be destroyed if it is re-
moved or if there is a power failure.
Insert the SD card only when the device is de-energized.

Avoid writing to SD cards as much as possible. Reasons:

- SD cards have a limited number of write cycles.
- If there is a voltage drop while a write operation is in progress, data loss is
highly likely to occur.
Remove the SD card only when the device is de-energized.

Before switching off, ensure that no software write operations to the SD card are

in progress.

Do not apply any force (SD cards are protected against reverse insertion).
Inserting the SD card
1 Push the SD card into the SD slot (A) until it snaps into position.
Removing the SD card
1 Push the SD card in the SD slot (A) all the way in.
This releases the lock mechanism and the SD card comes out of the SD slot a little.

2 Remove the SD card from the SD slot.
Touch display XV-102 10/2020 MN04802004Z-EN Eaton.com
6.4 Inserting and removing the SD card
6 Operation
57