Ebyte E180-Z5812SX Manual page 14

Chengdu Ebyte Electronic Technology Co.,Ltd.
address
Destination Read/
MAC address write
Equipment Read/
type write
channel Read/
write
Send mode Read/
write
Output mode Read/
write
Transmit Read/
power write
Remote Read/
configuration write
ID
Local Read/
network write
group number
Target Read/
network write
group number
Wake-up Read/
period (sleep write
time)
Lost parent Read/
node write
reconnection
period
Maximum Read/
number of write
reconnections
IO status Read/
write
PWM Read/
write
ADC value read
Copyright ©2012–2021, Chengdu Ebyte Electronic Technology Co., Ltd.
changed by the user (re-entry to the network)
64bitMAC
In fixed-point mode, use long address to send
E、S
They are: non-sleeping terminal, dormant terminal.
CH11～26
The physical channel where ZIGBEE works.
0、1、2、3、4、
The transmission modes of the configuration module are: broadcast mode,
5
multicast mode, short address on demand mode, long address on demand
mode, protocol on demand, and protocol multicast. For details, please see
the corresponding mode function introduction.
0、1、2、3、4、
Configure the data output mode of the module, respectively:
5
-37dbm～7dbm
Penetrate.
2 bytes
Data + short address.
1～254
Data + long address.
1～254
Data + RSSI;
0～2010
Data + short address + RSSI.
seconds
1～254
Data + long address + RSSI.
minutes
1～254 times
The output power of the module has high requirements for power
consumption. When the distance is not required, the transmission power
can be reduced to save average power consumption.
High/low
Used to determine whether the data received over the air is a remote
configuration command. Customers can change the unlimited
configuration ID according to their needs. The default is A8 8A.
1us～340ms
Used to configure the group number of the device in the network.
0～3300mv
It is used to configure the group number of the corresponding target when
the device is multicast.
E180-Z5812SX User Manual
13