Symptom
Unit will not
•
power on.
No sound output
•
from speakers.
Noise/Distortion in
•
sound output.
Unit fails to
•
respond.
The tape does not
•
play.
Cannot listen to
•
any station, or
signal appears
weak.
The sound is
•
distorted.
CD stops
•
immediately after
starting, or unit
pauses or stops
during play.
No sound.
•
CD playback is
•
noisy, or playback
stops or skips.
CD tray will not
•
open.
Buttons are not
•
functioning
correctly.
Decline in turntable
•
audio
performance.
Troubleshooting Guide
Possible Cause
Unit is unplugged.
•
The volume level is set too low.
•
The input selector does not match the
•
playback source.
The unit is too close to a TV set or another
•
interfering device.
It might result from external factors such as
•
ESD (Electro-static discharge).
The cassette tape is not inserted properly.
•
The tape has reached the end.
•
The station is not tuned-in properly.
•
A TV set is being used nearby and is
•
interfering with the radio reception.
The antenna is not oriented properly.
•
The CD is inserted upside down.
•
The CD is dusty or dirty or there is
•
condensation on the CD.
The CD player is paused.
•
The CD is scratched, damaged or warped.
•
The disc is very dirty.
•
FM/BLUETOOTH/AUX/PHONO/
•
TAPE mode is selected.
The unit is processing information
•
("--- Busy" is displayed).
The unit needs to be restarted.
•
The turntable stylus is worn out.
•
14
Solution
Connect the unit to
•
the AC power
supply.
Adjust the volume.
•
Select the correct
•
input source.
Turn off the TV or
•
other appliance,
and relocate the
unit.
Disconnect the
•
power cord and
external audio
device. Re-plug the
power cord after
one minute.
Insert the cassette
•
tape correctly.
Flip the cassette.
•
Properly tune-in the
•
desired station.
Turn-off the
•
interfering TV set.
Re-orient the
•
antenna until
reception improves.
Insert the CD with
•
the printed side
right-side up.
Carefully clean and
•
dry the CD.
Press the
•
PLAY/PAUSE
button.
Replace CD with an
•
undamaged one.
Carefully clean the
•
CD.
Select CD mode.
•
Wait until the unit
•
finishes processing.
Turn the unit off,
•
then on again.
Replace the stylus.
•