Uncrating Instructions; Important - Report Any Shipping Damage Immediately; Notice - Possible Equipment Damage; Warning - Personal Injury Hazard - Graham Field Hausted EPC500ST Operating Manual

2

UNCRATING INSTRUCTIONS

IMPORTANT — REPORT ANY SHIPPING DAMAGE IMMEDIATELY
WARNING:
Inform shipper of any damages — leave carton intact. Leave equipment in the
receiving area until inspection is complete.
NOTICE — POSSIBLE EQUIPMENT DAMAGE
s NOTICE: The crate contains fragile, expensive medical equipment. Uncrate and handle
carefully. If after uncrating the equipment you find any damage (no matter how slight),
report the damage to GF Health Products, Inc.
WARNING — PERSONAL INJURY HAZARD
WARNING:
When cutting bands, always use tool specifically designed for that purpose.
This will help avoid personal injuries possibly incurred when bands are cut and tension is
released.

ENVIRONMENTAL CONDITIONS

Operating

Temperature
Relative Humidity
Atmospheric Pressure
IMPORTANT: Follow each step in the order shown in these instructions.

UNPACKING INSTRUCTIONS

Your Hausted equipment has been carefully packed at our manufacturing plant to ensure safe
shipment to your medical facility. There are several procedures you must follow to put your new
equipment in service. These procedures only take a few minutes to complete and all are required
to ensure proper operation of the equipment.
1. Cut the two bands around the shipping carton.
2. Remove the top cap of the carton and remove the two box side panels.
3. Remove the equipment from the carton.
4. Check to see if all features of the equipment work properly. If all features work, advance
to step 5. If any of the features do not work properly, call GF Health Products, Inc. at
1.770.368.4700 if purchased within the U.S., or the authorized distributor from whom you
purchased the unit if outside the U.S.
Info: Plug the unit into a wall socket prior to checking any electric features. The battery will
reach full charge after approximately 10 hours.
5. Clean the equipment using mild detergent to remove any dirt accumulated during shipment,
and place the equipment into service.
EPC500ST-INS-LAB-RevA21
5°C to 40°C
20% to 90% @ 30°C
700 to 1060 hPa

Storage and Transport

Temperature
Relative Humidity
Atmospheric Pressure
-10°C to 50°C
20% to 90% @ 30°C
700 to 1060 hPa
8