Installation Of New Side Burner - Cal Flame 3000 Owner's Manual

Installation of Nw Side Burner

INSTALLATION OF NEW SIDE BURNER

1. Install side burner into an area of 17-1/2 inches long, 11 inches wide and 3 inches deep.
2. Assemble a 3/8 pipe nipple to the 3/8 pipe tee using teflon tape or pipe sealant. Use only sealant that is
approved for use on LP gas.
3. Install the pipe tee assembly to the grill intake pipe with pipe sealant. Tighten assembly and align the branch
opening of the tee with the hole of the cabinet.
4. Connect the flexible hose (male end) to the pipe tee with pipe sealant.
5. Install and secure the side burner into the island by simply setting in place.
6. Connect the female end of the flexible hose to the side burner intake pipe with pipe sealant.
7. Connect gas supply to the grill.
8. Check for gas leaks using soap water solution. (1 part liquid soap, 3 parts water).
Items Included with Barbecue
1) "T" adapter (3/8")
2) 2 each Hose 3/8" Fittings
3) Regulatorw/ Hose
"T" Adapter (3/8" Threaded)
To grill, located
underneath and
behind grill
From Grill
3/8" Fittings
NOTE: You will need to use a gas rated
sealer on all gas connectors (Tape,
pipe dope, ect.)
Owner's Manual
BARBECUE GASLINE
To side burner, located
underneath behind burner.
From Side Burner
To Propane Tank
Gas Line
Open barbecue door. Install hose with regulator on propane
A
tank. Then connect other end to "T" adapter. Make sure to
use gas rated tape seal when installing adapter to insure
proper seal.
C
B
Grill
A
Then take other end of "T" adapter with hose attached
B
and connect to end of male located underneath and at
the back of the grill. (Use gas rated tape seal on all
connections).
Connect the last open line to the side burner
C
(Use gas rated tape seal on all connections)
Figure 33. Side Burner Installation
Owner's Manual
Page 30