The Handy THLSV7 Instruction Manual page 6

STAY ALERT
Do not operate the machine while under the influence of drugs, alcohol, or any medication that could affect
your ability to use it properly. Do not use this machine when you are tired or distracted from the job at hand.
Be aware of what you are doing at all times. Use common sense.
AVOID DANGEROUS CONDITIONS
Always operate your logsplitter on dry, solid, level ground. Never operate your logsplitter on slippery, wet,
muddy, or icy surfaces. The location you choose should be free from any tall grass, brush, or other
interferences. There should be plenty of room for handling, and help the operator stay alert. Keep your work
area clean and well light. Cluttered areas invite injuries. To avoid tripping, do not leave tools, logs, or other
components laying around the work area. Do not use the logsplitter in wet or damp areas or expose it to rain.
Do not use it in areas where fumes from paint, solvents or flammable liquids pose a potential hazard.
INSPECT YOUR MACHINE
Check your logsplitter before turning it on. Keep guards in place and in working order. Form a habit of checking
tools are removed from the working area before turning it on. Replace damaged, missing or failed parts before
operating the machine.
DRESS PROPERLY
Do not wear loose clothing, gloves, neckties or jewellery (rings, wrist watches). They can be caught in moving
parts. Protective electrically non-conductive gloves and non-skid footwear are recommended when working.
Wear protective hair covering to contain long hair, preventing it from get caught in machinery.
PROTECT EYES & FACE
Any logsplitter may throw foreign objects into the eyes. This can cause permanent eye damage. Always wear
safety goggles. Everyday eye-glasses have only impact resistant lenses. They are not safety glasses.
AVOID ELECTRICAL SHOCK
Check that the electric circuit is adequately protected and that it corresponds with the power, voltage and
frequency of the motor. Check that there is a ground connection and a regulation differential switch upstream.
Ground the logsplitter. Prevent body contact with grounded surfaces: pipes, radiators, ranges, and refrigerator
enclosures.
Never open the pushbutton box on the motor. Should this be necessary, contact a qualified electrician. Make
sure your fingers do not touch the plug's metal prongs when plugging or unplugging the logsplitter.
After installation, the degree of protection of the BSI and the SEV approved plug and socket combination shall
be IP44D at least. Avoid excessive bending and twisting of the connection between the power cord of the
British plug and the junction box.
KEEP BYSTANDERS AND CHILDREN AWAY
The logsplitter must be always operated by one person only. Other people should keep a safe distance from
the work area (10 metres recommended), especially when the logsplitter is under operation. Never use
another person to help you with freeing a jammed log.
INSPECT YOUR LOG
Make sure there are no nails or foreign objects in logs to be split. The ends of the logs must be cut square.
Branches must be cut flush with the trunk.
DO NOT OVERREACH
Operating floor must not be slippery. Always keep proper footing and balance. Never stand on the logsplitter.
Serious injury could occur if the tool is tipped or if the cutting tool is unintentionally contacted. Do not store
anything above or near the logsplitter where anyone might stand on the tool to reach them.
AVOID INJURY FROM UNEXPECTED ACCIDENT
Always pay full attention to the movement of the log-pusher. Do not attempt to load the log on until the log-
pusher has stopped. Keep hands out of the way of all moving parts.
PROTECT YOUR HANDS
Keep your hands away from splits and cracks which open in the log; They may close suddenly and crush or
amputate your hands. Do not remove jammed logs with your hands.
DO NOT FORCE TOOL
It will do a better and safer job at its design rate. Never try to split logs larger than those indicated in the
specifications table. This could be dangerous and may damage the machine. Don't use the logsplitter for a
purpose for which it was not intended.
NEVER LEAVE MACHINE RUNNING UNATTENDED
Do not leave the machine unattended, until it has come to a complete stop and the power removed from the
electrical source.