Table of Contents
Advertisement
Quick Links
This .pdf document is bookmarked
Operating Instructions and Parts Manual
DC-1200VX Series Dust Collectors
Now with
DC-1200VX with Bag Filter Kit
DC-1200VX with Canister Kit
JET
427 New Sanford Road
LaVergne, Tennessee 37086
Part No. M-710701
Ph.: 800-274-6848
Revision C1 09/2018
www.jettools.com
Copyright © 2014 JET
Advertisement
Table of Contents
Related Manuals for Jet DC-1200VX Series
Summary of Contents for Jet DC-1200VX Series
- Page 1 This .pdf document is bookmarked Operating Instructions and Parts Manual DC-1200VX Series Dust Collectors Now with DC-1200VX with Bag Filter Kit DC-1200VX with Canister Kit 427 New Sanford Road LaVergne, Tennessee 37086 Part No. M-710701 Ph.: 800-274-6848 Revision C1 09/2018 www.jettools.com...
-
Page 2: Warranty And Service
Accessories; Shop Tools; Warehouse & Dock products; Hand Tools; Air Tools NOTE: JET is a division of JPW Industries, Inc. References in this document to JET also apply to JPW Industries, Inc., or any of its successors in interest to the JET brand. -
Page 3: Table Of Contents
Table of Contents Warranty and Service ..............................2 Table of Contents ................................3 Warnings ..................................4 Introduction ..................................5 Specifications ................................6 Unpacking ..................................7 Shipping Content ................................7 Base Units ................................. 7 Canister Filter Kit ............................... 8 30 Micron Bag Filter Kit ............................. 8 5 Micron Bag Filter Kit (Optional) .......................... -
Page 4: Warnings
Do not use this dust collector for other than its intended use. If used for other purposes, JET disclaims any real or implied warranty and holds itself harmless from any injury that may result from that use. -
Page 5: Introduction
This machine has been designed and constructed to provide consistent, long-term operation if used in accordance with instructions set forth in this manual. If there are any questions or comments, please contact either your local supplier or JET. -
Page 6: Specifications
Stock Number (Remote Control Switch only) .................... 708636T The above specifications were current at the time this manual was published, but because of our policy of continuous improvement, JET reserves the right to change specifications at any time and without prior notice, without incurring obligations. -
Page 7: Unpacking
Unpacking Shipping Content Base Unit The table below lists the shipping cartons that are included with the various models of the DC-1200 Dust (SN 710701 and 710703) Collector. 1 – Housing (A) Locate your particular model and verify that you 2 –... -
Page 8: Canister Filter Kit
Canister Filter Kit 30 Micron Bag Filter Kit (SN 708639B) (SN 708636F) 1 – Handle (O) 1 – Upper Bag Hanger (Y) 1 – Canister Filter (P) 1 – Hanger Bracket (Z) 1 – Snap Ring (Q) 1 – Collector Bag (X) 5 –... -
Page 9: Base Unit Assembly
Base Unit Assembly Base Install four casters to the under side of the base as pictured in Fig. 2. Referring to Figure 1: Thread the hex nut (B) onto the caster shaft. Then slide the lock washer (A) over the caster shaft. Thread the caster shaft into the threaded hole on the underside of the base, turn until snug. -
Page 10: Cone Assembly
Install the housing (A, Fig. 5) to two support legs (B, Fig. 5) using four M8 x 16 hex cap bolts, eight M8 flat washers, and four M8 hex nuts (C, Fig. 5). Be sure hose opening faces fan housing. Note: For models DC-1200VX-BK1 or DC- 1200VX-BK3 only –... -
Page 11: Filter Bag Kit Assembly
Filter Bag Kit Assembly If you purchased Model DC-1200VX-BK1 or DC-1200VX- BK3 Dust Collector, this section describes the assembly and installation of the contents of the 30 Micron Filter Bag Kit (SN 708636F). These instructions also apply to the optional 5 Micron Filter Bag Kit (SN 708636MF). Filter Bag Installation Referring to Figure 8: Place the hanger (A) on the hanger bracket (B). -
Page 12: Canister Kit Assembly
Canister Kit Assembly If you purchased Model DC-1200VX-CK1 or DC-1200VX- CK3 Dust Collector, this section describes the assembly and installation of the contents of the Canister Kit (SN 708636F). Canister Filter Mount the handle onto the canister filter with two M10 hex nuts, two M10 flat washers, and a M10 lock washer (Figure 10). -
Page 13: Electrical Connections
Electrical Connections Dust Collector RF Remote Power Control (optional) All electrical connections must be done by a qualified electrician. The DC-RC230 Remote Power Control (Figure 14) All adjustments or repairs must be done with the should be used for activating Dust Collection units dust collector disconnected from the power source, powered by 230V only up to 3HP, 1 Phase. -
Page 14: Changing Operating Frequency
Changing Operating Frequency Note: Mounting hardware is not included and must be supplied by the machine’s owner or user. If several devices are controlled by the same type Place RC Power Control Unit (A) on the open remote control unit, each remote control unit can be set clearing of the base (B) of the dust collector near to operate at its' own unique operating frequency as the motor (C). -
Page 15: Maintenance
Dryer vent hose is not container. acceptable for this purpose. Contact your nearest JET distributor for the full line of JET Dust Collector Hoses Turn the bag inside out and clean. and Accessories. Customize your installation and... -
Page 16: Parts Breakdown For The Dc-1200Vx Dust Collector
Parts Breakdown for the DC-1200VX Dust Collector... -
Page 17: Ordering Replacement Parts
Ordering Replacement Parts To order parts or reach our service department, call 800-274-6848, Monday through Friday (see our website for business hours, www.jettools.com). Having the Model Number and Serial Number of your machine available when you call will allow us to serve you quickly and accurately. Parts List for the DC-1200VX Dust Collector Index No. - Page 18 ....DC1200-53 ....Grounding Label (not shown) ................ 1 ....DC1200-54 ....Direction Label (not shown) ................1 ....STRIPE-1-3/4 .... JET Stripe (not shown) ..........1-3/4” ....... per ft ....DC1100VX-56 ... Vortex Cone Decal (not shown)………….88.9x28.58mm (3-1/2”x1-1/8”) ..1...
-
Page 19: Canister Filter Kit (708639B)
Canister Filter Kit (708639B) Index No. Part No. Description Size ....708639B ....Canister Filter Kit (index #1-24) ............... 1 ....331050 ...... Handle ......................1 2 ....TS-1540071....Hex Nut ..............M10 ....... 2 3 ....TS-1550071....Flat Washer ............. M10 ....... 2 4 .... -
Page 20: Micron Filter Bag Kit (708636F)
30 Micron Filter Bag Kit (708636F) Index No. Part No. Description Size ....708636F ....30 Micron Filter Bag Kit (index #1-5) ............... 1 ....708698 ...... Filter Bag ..............30 Micron Bag ....1 2 ....AB410012....Retainer Strap ....................1 3 .... -
Page 21: 5-Micron Filter Bag Kit (708636Mf) Optional Accessory
5-Micron Filter Bag Kit (708636MF) Optional Accessory Index No. Part No. Description Size ....708636MF ....5-Micron Filter and Collection Bag Kit (index # 1-6) 1 ....708706 ...... Filter Bag ..............5 Micron ......1 2 ....AB410012....Retainer Strap ....................1 3 .... -
Page 22: Electrical Connections
Electrical Connections Wiring Diagram For 3 Phase 230/460V Dust Collector (DC-1200VX) Wiring Diagram For Single Phase 230V Only Dust Collector (DC-1200VX) - Page 24 427 New Sanford Road LaVergne, Tennessee 37086 Phone: 800-274-6848 www.jettools.com...