Table of Contents
Advertisement
Quick Links
Operating Instructions and Parts Manual
Dust Collector
DC-1200 Series Dust Collectors
DC-1200BK
WALTER MEIER (Manufacturing), Inc.
427 New Sanford Road
LaVergne, Tennessee 37086
Ph.: 800-274-6848
www.waltermeier.com
DC-1200CK
Copyright © 2010 Walter Meier (Manufacturing), Inc.
This .pdf document is bookmarked
Part No. M-710700
Revision B 11/2010
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Jet DC-1200CK
Summary of Contents for Jet DC-1200CK
- Page 1 Operating Instructions and Parts Manual Dust Collector DC-1200 Series Dust Collectors DC-1200BK WALTER MEIER (Manufacturing), Inc. 427 New Sanford Road LaVergne, Tennessee 37086 Ph.: 800-274-6848 www.waltermeier.com DC-1200CK Part No. M-710700 Revision B 11/2010 Copyright © 2010 Walter Meier (Manufacturing), Inc.
-
Page 2: Warranty And Service
Warranty and Service Walter Meier (Manufacturing) Inc., warrants every product it sells. If one of our tools needs service or repair, one of our Authorized Service Centers located throughout the United States can give you quick service. In most cases, any of these Walter Meier Authorized Service Centers can authorize warranty repair, assist you in obtaining parts, or perform routine maintenance and major repair on your JET tools. -
Page 3: Table Of Contents
Cleaning the Filter Bag - DC-1200BK and DC-1200BK-3... 15 Removing the Collector Bag – DC-1200BK and DC-1200BK-3 ... 15 Cleaning the Canister Filter – DC-1200CK and DC-1200CK-3 ... 15 Removing the Collector Bag – DC-1200CK and DC-1200CK-3 ... 15 Motor ... 15 Connecting the Dust Collector to a Machine ... -
Page 4: Warnings
4. This dust collector is designed and intended for use by properly trained and experienced personnel only. If you are not familiar with the proper and safe operation of a dust collector, do not use until proper training and knowledge have been obtained. -
Page 5: Introduction
22. Do not use the dust collector for anything except wood dust. Materials such as liquids, metal shavings, metal dust, screws, glass, plastic or rock can cause sparks and/or damage when coming into contact with any part of the dust collector. -
Page 6: Specifications
DC-1200BK-1 (Single Phase, with 30 Micron Bag Filter Kit) ..710700BK DC-1200BK-3 (Three Phase, with 30 Micron Bag Filter Kit) ..710720BK DC-1200CK-1 (Single Phase, with Canister Filter Kit) ..710700CK DC-1200CK-3 (Three Phase, with Canister Filter Kit) ..710720CK Base Machine Stock Number... -
Page 7: Unpacking
2. Check contents of each carton against the ship- ping content listings on this and the following page. 3. Report any damage to your distributor. 4. Do not discard any shipping material until after the dust collector has been assembled and is running properly. DC-1200BK DC-1200CK DC-1200BK-3 DC-1200CK-3 Table –... -
Page 8: Canister Filter Kit
Canister Filter Kit (SN 708639B) 1 – Handle (O) 1 – Canister Filter (P) 1 – Snap Ring (Q) 5 – Collector Bags (R) 1 – Canister Filter Hardware Bag (SN DC1100-CHP) Contains: (2) M10 Hex Nuts (S) (2) M10 Flat Washers (T) (1) M10 Lock Washer (U) (4) Knobs (V) Canister Filter Kit Contents... -
Page 9: Base Unit Assembly
M8 x 16 hex cap screws, and M8 flat washers (B). Tighten with a 13mm wrench. The dust collector must not be connected to the power source during assembly. Failure to comply may result in serious injury! Referring to Figure 3: 4. -
Page 10: Cone Assembly
This completes the Base Unit assembly. If you purchased the DC-1200BK or DC-1200BK-3 Dust Collector (filter bag version), continue on the following page. If you purchased the DC-1200CK or DC- 1200CK-3 Dust Collector (canister filter version), proceed to Canister Kit Assembly section on page 12. -
Page 11: Filter Bag Kit Assembly
Filter Bag Kit Assembly If you purchased Model DC-1200BK or DC-1200BK-3 Dust Collector, this section describes the assembly and installation of the contents of the 30 Micron Filter Bag Kit (SN 708636F). These instructions also apply to the optional 5 Micron Filter Bag Kit (SN 708636MF). -
Page 12: Canister Kit Assembly
Canister Kit Assembly If you purchased Model DC-1200CK or DC-1200CK-3 Dust Collector, this section describes the assembly and installation of the contents of the Canister Kit (SN 708636F). Canister Filter 1. Mount the handle onto the canister filter with two M10 hex nuts, two M10 flat washers, and a M10 lock washer (Figure 10). -
Page 13: Electrical Connections
20 amp circuit breaker or fuse. The DC-1200BK-3 and DC-1200CK-3 are rated at 3 Phase 230V/460V, Prewired 230V. If you want to run these on 460V refer to the wiring diagram found on the inside of the switch box cover. -
Page 14: Changing Operating Frequency
1. Place RC Power Control Unit (A) on the open clearing of the base (B) of the dust collector near the motor (C). 2. Using a marker, mark the base through the mounting holes of the power control units mounting tabs. -
Page 15: Maintenance
Collector Hoses and Accessories. Customize your installation and obtain maximum performance with JET's dust hoods, hoses, clamps, fittings, and blast gates. Cleaning the Canister Filter – DC-1200CK and DC-1200CK-3 this machine before turning switch off and removing plug from power source. Failure to... -
Page 16: Parts Breakdown For The Dc-1200 Dust Collector
Parts Breakdown for the DC-1200 Dust Collector... -
Page 17: Ordering Replacement Parts
Having the Model Number and Serial Number of your machine available when you call will allow us to serve you quickly and accurately. Parts List for the DC-1200 Dust Collector Index No. Part No. 1 ... 411035W ...Impeller Housing... 1 2 ... - Page 18 Index No. Part No. Description Size ... DC1200A-NP...Name Plate (not shown) ... 1 ... DC1100-HP ...Hardware Package (not shown) ... 1 ... DC1100-HP2 ...Hardware Package for cone assy (index # 49 thru 53)... 1 ... DC1200A-CS...Centrifugal Switch (not shown) ... 1 ...
-
Page 19: Canister Filter Assembly
Canister Filter Assembly Index No. Part No. Description Size 1 ... 331050 ... Handle ..1 2 ... TS-1540071... Hex Nut ... M10 ...2 3 ... TS-1550071... Flat Washer ... M10 ...2 4 ... TS-2361101... Lock Washer ... M10 ...1 5 ... -
Page 20: 30 Micron Filter Bag Assembly
30 Micron Filter Bag Assembly Index No. Part No. Description Size 1 ... 708698 ... Filter Bag ... 30 Micron Bag ...1 2 ... AB410012 ... Retainer Strap ..1 3 ... 708699A... Collection Bag ..1 4 ... 430038 ... Hanger ... 30 Micron Bag Hanger ...1 5 ... -
Page 21: 5-Micron Filter Bag Assembly (Optional Accessory)
5-Micron Filter Bag Assembly (Optional Accessory) Index No. Part No. Description Size ... 708636MF ...5-Micron Filter and Collection Bag Kit (index # 1-6) ... 1 ... 708706...Filter Bag ...5 Micron ... 1 2 ... AB410012 ...Retainer Strap ... 1 3 ... 331038...Snap Ring ... 1 4 ... - Page 22 Wiring Diagram For 3 Phase 230V/460V Dust Collector (DC-1200M-3) Wiring Diagram For Single Phase 230V Only Dust Collector (DC-1200M)
- Page 24 WALTER MEIER (Manufacturing) Inc. 427 New Sanford Road LaVergne, Tennessee 37086 Phone: 800-274-6848 www.waltermeier.com...
Need help?
Do you have a question about the DC-1200CK and is the answer not in the manual?
Questions and answers