Table of Contents
Advertisement
SUPERSERVER 6028TP-HTR/HTTR/HTFR USER'S MANUAL
Watch Dog Enable/Disable
Watch Dog (JWD1) is a system monitor
that can reboot the system when a
software application hangs. Close pins
1-2 to reset the system if an application
hangs. Close pins 2-3 to generate
non-maskable interrupt signals for the
application that hangs. See the table on
the right for jumper settings. Watch Dog
must also be enabled in the BIOS.
VGA Enable
Jumper JPG1 allows the user to enable
the onboard VGA connectors. The
default setting is pins 1-2 to enable the
connection. See the table on the right for
jumper settings.
BMC Enable
Jumper JPB1 allows you to enable the
onboard BMC (Baseboard Management
Controller) to provide IPMI 2.0/KVM
support on the serverboard. Be sure to
remove the power cord before closing
pins 2-3 to disable the BMC. See the
table on the right for jumper settings.
Jumper Settings
Jumper Setting
Pins 1-2
Pins 2-3
Open
Jumper Settings
Jumper Setting
Pins 1-2
Pins 2-3
Jumper Settings
Jumper Setting
Pins 1-2
Pins 2-3
5-18
Watch Dog
Definition
Reset
NMI
Disabled
VGA Enable
Definition
Enabled
Disabled
BMC Enable
Definition
BMC Enabled
Normal
Advertisement
Table of Contents
